3 Easy Steps to Repair Roof Drip Edge

More often than not, the roof drip edge causes a lot of problems, resulting in a roof repair in Brampton. The problem is simple—the proper installation sequence remains a mystery to most homeowners and DIY-ers. The result? You have a drip edge that doesn’t do its job—protect the roof decking and fascia board from water and rot. If you have faced similar problems, don’t worry, there’s a quick fix to this issue. The three steps given below are all you need. 

Tools and materials required

  • Roofing felt
  • Roofing nails
  • Hammer
  • Stapler and staples
  • Drip edge
  • Tin snips
  • Ice and water shield

3 easy steps for roof drip edge repair

You may be confused over the sequence to follow when installing the roof drip edge, ice and water shield, and roofing felt since both the eaves and gable ends are involved. Fret not, these three steps help simplify the process. So, let’s go.

  1. Installing the flashing properly

The proper sequence of installing the drip edge is the following: 

  1. Install the drip edge along the eaves
  2. Add the underlayment (felt; ice and water barrier)
  3. Install the drip edge along the gable end

Not following this sequence can lead to a misfitting drip edge that causes leaks and rot in your roof. Ideally, you place the edge at the eaves end first and then lay down the felt or barrier before finishing it with the drip edge at the gable end. 

  1. Placing drip edge along the gable ends

This is the step that most people falter at. Many people tend to put both the ends of the drip edge first and then the underlayment. Instead, you need to make sure to lay down all the underlayment first. 

Then, cover the ends of the layer with the drip edge. This ensures that the rain that gets blown under the shingles on a windy day will flow over the drip edge and not the sheathing. Keeping the edge over the paper will also ensure that the paper doesn’t fly off or shift as you install the shingles. 

  1. Cutting eave pieces

While placing the drip edge over the sheathing is always the recommended approach, you can also add to the efficiency by cutting the corners of the gable and eave pieces. This ensures that the paper fits well within the edge and doesn’t spill over, giving you clean locking corners. 

Conclusion

Roof drip edge problems are more common than you’d think. Just a small misplacement of the felt can cause such a mess and lead to your roof being damaged. Save yourself the trouble by getting the expert help when it comes to repairing the drip edge or following the above-given tips to the T. Ready to fix that roof, yet?

 

0 comments
0 likes
Prev post: All You Need to Know About Gilbert Real Estate Market in 2021Next post: 4 Reasons to Move to Garland Texas

Related posts

Leave a Reply

Your email address will not be published. Required fields are marked *